WORLDWIDE DELIVERY
24/7 HELP CENTER
SHOP WITH CONFIDENCE
SAFE PAYMENT
Edgecore Datacenter switch DCS560-AS9817-64O-AS9817-64D-with 64*QSFP-DD800/OSFP800
The Edgecore DCS560 is a high-performance, low-latency switch for high-performance data centers.
Application Scenarios:
- Spine Switch
A next-generation, highest-capacity switch for data center spine use case. Breakout options include 2 x 400G, 4 x 200G, and 8 x 100G
per port, with a maximum of 320 logical ports. Offers reduced cost and power per bit.Scalable and enables migration to 400G leaf
connectivity in data centers.
- AI/ML Clusters
Standards-based (Ethernet) networking for AI/ML training, leveraging low latency and high-throughput RoCEv2.Reduces Job
Completion Time (JCT) using the cognitive routing and congestion management capabilities of the switch.Fully programmable
telemetry enables sophisticated on-chip applications for heightened network insight and efficient network management.
- High-Performance Computing
The large number of high-capacity Ethernet ports enables server interfaces to transition to higher speeds and denser networks.
Enables the virtualization of compute and storage with VxLAN switching and routing.
Key Features and Benefits
- OSFP800 or QSFP-DD800 switch ports, each supporting 1 x 800 GbE (100G PAM4), or via breakout cables 2 x 400G GbE, 4 x 200 GbE, or 8 x 100 GbE.
- OSFP800 or QSFP-DD800 switch ports also support 1 x 400 GbE (50G PAM4), 1 x 100 GbE (NRZ), and via breakout cables 2 x 200 GbE, 4 x 100 GbE, or 8 x 50 GbE.
- Up to 24 W power budget per OSFP800 and QSFP-DD800 port.
- Incorporates Broadcom Tomahawk 5 switch series silicon.
- Highest Radix: Up to 320 logical ports on a single chip, low latency
- Cognitive/adaptive routing and dynamic load balancing
- Advanced shared buffering
- Programmable in-band telemetry
- Supports end-to-end congestion control
- Power efficient due to a monolithic 5nm die
- Hardware-based link failover for network resiliency and reduced job completion time
- Support for SRv6
- BMC module with serial-over-LAN support
- SyncE and PTP support with 1PPS, 10MHz, and ToD connectors on the front panel
- Contains e-fuses to protect transceivers and internal components
- Standby power mode
- 2 RU form factor
- Supports hot/cold aisles with front-to-back airflow SKU.
- All ports on front; PSUs and fans accessible from rear.
- Hot-swappable, load-sharing, redundant 3000 W AC PSUs.
- 3+1 redundant, hot-swappable fan modules.
- Hardware switch pre-loaded with Open Network Install Environment (ONIE) for automated loading of compatible open source and commerical NOS offerings.
Interfaces
Models
Ports
- Switch Ports: 64 x OSFP800 or QSFP-DD800 800GbE
- Logical Ports: Max. 320
- Port Modes:
1 x 800G (8 lanes 100G PAM4)
2 x 400G (4 lanes 100G PAM4) breakout
4 x 200G (2 lanes 100G PAM4) breakout
8 x 100G (1 lane 100G PAM4) breakout
1 x 400G (8 lanes 50G PAM4)
2 x 200G (4 lanes 50G PAM4) breakout
4 x 100G (2 lanes 50G PAM4) breakout
8 x 50G (1 lane 50G PAM4) breakout
1 x 100G (4 lanes 25G NRZ)
- Management Ports on Port Side:
1 x RJ-45 serial console
1 x RJ-45 1000BASE-T management
2 x SFP28 25G ASIC management
1 x USB 3.0 storage port
- Supported Transceivers and Cables:
TBD
Key Componets
- Switch Silicon: BCM78900 Tomahawk 5
- CPU Module:
Processor: Intel® Xeon® Processor D-1713NTE 4-Core 2.2 GHz
SPI Flash: 64MB x 2
Memory: 32GB DDR4 SO-DIMM with ECC
Storage: 240G m.2 2280 NVMe SSD
TPM: TPM2.0
- BMC: AST2600 with OpenBMC
- Timing and Sync:
1PPS port, 10 MHz port, ToD port, SyncE, IEEE 1588v2 PTP
Performance
- Switching Capability: 51.2 Tbps full duplex
- Forwarding Rate: TBD
- Latency: <1µs
- Jumbo Frames: Up to 9416 Bytes
- Subject to NOS:
VXLAN RIOT support
SRv6 support
Physical and Environmental
- Dimensions (WxDxH): 44 x 64.92 x 8.7 cm (17.32 x 25.56 x 3.43 in.)
- Weight: 21.5 kg (47.4 lb), with 2 PSUs and 4 fans installed
- Fans: Hot-swappable 3 + 1 redundant fans
- Storage Temperature: -40°C to 70°C ( -40°F to 158°F)
- Operating Temperature: 0°C – 40°C
- Operating Humidity: 5% – 95% non-condensing
- Operating Altitude: 1800 m
- MTBF: TBD
Soſtware
- Switch is loaded with Open Network Install Environment (ONIE) soſtware installer
- Compatible with the following NOS options: Open source options, plus commercial NOS offerings.
System and Port LEDs
- Port LEDs: Link Status, Activity, Rate
- Management Port LEDs: Link Status, Activity
- RJ-45 Port: Link Status, Activity
- System LEDs: Locator, Diagnostic, PSU, Fan Status, Alarm
- Reset button
Power
- PSUs: 2 redundant, load-sharing, hot-swappable 3000W AC
- AC PSU:
AC Input Ranges:
100-127VAC at 50-60Hz (16 A/1500 W max.)
200-240VAC at 50-60Hz (16 A/3000 W max.)
200-240VAC may be required for power redundancy under full loading.
AC Inlet: IEC 60320 C20
Power Efficiency: >88%
- Power Draw: TBD (<2775 W)
- Power Budget: 24W on OSFP800 and QSFP-DD800 ports
Regulatory
- Emissions:
EN 55032 Class A
AS/NZS CISPR32
EN 61000-3-2
EN 61000-3-3
FCC Class A
ICES-003
VCCI-CISPR32
- Immunity:
EN 55035
IEC 61000-4-2/3/4/5/6/8/11
- Safety:
UL (CSA 22.2 No 62368-1 & UL 62368-1)
CB (IEC/EN 62368-1)
- Environmental:
GR63-CORE (Pre-test)
- RoHS-2.0 Compliant
- Electrical and Electronic Equipment (WEEE Directive 2002/96/EC)
- Country of Origin: Taiwan (TAA Compliant)
Data sheet content
Switch-Router
- Type of switch
- Data center
- Number of ports
- 128 , 64 , 96 , 320
- Port speed
- 100G , 400G , 800G , 200G , 50G
- Uplink port
- 32 , 64 , 64-128 , 128-320
- Uplink Port speed
- 100G , 400G , 800G , 200G
- type of ports
- QSFP-DD800 , OSFP800
- type of uplink ports
- QSFP-DD800 , OSFP800
- Layer of switch
- VxLAN
- IP version
- IPV4 , IPV6
- Switch power consumption
- 2524-3000W
- Switch Capacity
- 51.2T
- Redundant power and fan
- Modular design of power supply and fan , hot swappable , fan speed control and alarm detection
16 other products in the same category
Specifications
Switch-Router | |
---|---|
Type of switch | Data center |
Number of ports | 128, 64, 96, 320 |
Port speed | 100G, 400G, 800G, 200G, 50G |
Uplink port | 32, 64, 64-128, 128-320 |
Uplink Port speed | 100G, 400G, 800G, 200G |
type of ports | QSFP-DD800, OSFP800 |
type of uplink ports | QSFP-DD800, OSFP800 |
Layer of switch | VxLAN |
IP version | IPV4, IPV6 |
Switch power consumption | 2524-3000W |
Switch Capacity | 51.2T |
Redundant power and fan | Modular design of power supply and fan, hot swappable, fan speed control and alarm detection |